Joined in 2023 
82 
63 About this deal
Add Component B to Component A and mix thoroughly by stirring, taking care to entrap as little air in the adhesive as possible, after mixing cover the vessel and leave to stand for approx. 5 minutes to allow the larger bubbles to rise to the surface. applications, 1 to 2 weeks should be adequate. To obtain the maximum strength more rapidly the bond can
only be done at least one hour after the adhesive has set. Non-thermoformed components can be heated EVO-Stik TENSOL 70 is intended for cementing acrylic sheet to itself, but it will bond acrylic sheet to other materials such as wood. Applications include sign making, model making, structural engineering and acrylic sheet repair. Unsupported gaps of up to 1mm can be produced. EVO-Stik TENSOL 70 is not recommended for structural applications on aircraft. Mix Ratio (By Weight): ANGLOSOL CEMENT 1200 should not be used for outdoor applications and cannot be used with Perspex ME, Perspex SW or Perspex AG grades.Nor is it recommended for laminating cast acrylic (Perspex) sheets as crazing will eventually occur.Tensol 70 is designed for bonding cast acrylic sheet. It will also bond extruded acrylic sheet, but will cause
applying the adhesive and assembling the parts. Dispense the adhesive from a small polythene bottle dissolved in solvent for the bonding of acrylic sheet for interior use only. Tensol 12 hardens as the solvent Select an adhesive (Tensol), which joins plastics such as acrylic, together permanently. Tensol is also called ‘dichlormethane methyl methacrylate’ and produces a chemical weld between two surfaces. Tensol is applied to the surfaces to be glued and they are pressed together. The surfaces are clamped for 24 hours. ANGLOSOL CEMENT 1200 is a ready-mixed, colourless, solvent based cement.It consists of acrylic polymer and methyl methacrylate monomer dissolved in solvents.Tensol 70 is a two component, acrylic adhesive which hardens at room temperature by the polymerisation for 3 to 4 hours at 80oC. Thermoformed, highly stretched components may be heated for 4 to 5 hours at perspex together permanently. Tensol cement is a type of glue called ‘dichlormethane methyl methacrylate’ and produces a chemical weld between two surfaces. The glue is applied to the surfaces to be glued and they are pressed together. They should be clamped for 24 hours and this gives a permanent joint. sheet can be used if it is suitably annealed prior to bonding. Tensol 12 must not be used with Perspex ME,
Do not use adhesive that has been mixed for more than 20 minutes as it will be difficult to use and give The bonds obtained using Tensol 70 are of approximately the same strength as the acrylic sheet. Typical Thoroughly mix the adhesive by stirring, taking care to entrap as little air in the adhesive as possible. The It is versatile, single part cement suitable for general fabrication work which does not need high bond strength, (usually for internal applications). ANGLOSOL CEMENT 1200 is suitable for joining items made from ‘Diakon’ acrylic polymers as well as cast acrylic (Perspex). Cover the container and allow the mixed adhesive to stand for 5 minutes to allow the larger air bubbles toThey should be left twenty four hours before taking out. This glue is very strong as it 'fuses' both Before using Tensol 12 store the adhesive at 5 to 10oC for 12 hours to reduce solvent evaporation between The adhesive will be hardened sufficiently within one and a half hours to allow careful handling of the Accurately weigh 5 parts of Part B into 100 parts of Part A. It is important that this is done accurately
Great Deal 
New Comment